Thers not much info about the ragdoll editor, perhaps this is the best: http://cubeengine.com/forum.php4?action ... t=20#69050 and there is a little in the cubewiki. The ragdoll editor and I go back a while, and its been a pretty unhappy relationship. I have made a little progress, I have finally been able to load an md5 mesh. This small victory required a number of steps, which I will list for you:
1. copy your md5 mesh file into the folder containing the ragdoll editor, this just makes it easier.
2. run ragdoll.exe. Mrfixit is the default mesh, which will load
3. type ` to bring up the console (at the bottom of the screen)
4. type loadmodel yourmodelname
5. do not be disturbed when your model does not appear to load.
6. press the - key. This will 'quicksave' your model as the quicksave default.
7. quit the editor by typing quit at the console.
8. rub your stomach anticlockwise 3 times with your left hand while patting your head with the right.
9. run ragdoll.exe again - your model should now be loaded and ready to rag and roll.
Phew, after all that I am ready to go, but wtf do I do? Is there any documentation how to actually use it? Does it do iqm or smd?