FreeGameDev

Hi

I downloaded and installed game to win7 32bit and it seems to work well. Tested also my driving wheel and it seems to almost work.
The only problem is that the steering wheel turning range is too large. Even i turn the wheel to some side limit the car turns only very slowly and I cant drive steep curves..

I noticed that force feedback is not supported in windows, but should the wheels work in general? Are there some param to tune in config or ..
it is so close to work..

thanks for any clues..

There is no sensitivity or multipler for Input (was some time ago).
But generally you can adjust "Steering range multipliers".
Tab: Setup, on right, bottom there are those sliders. Try setting the one for Simulation to higher. Maybe it helps.
Easy simulation mode has lower steering range, maybe too low, it's more vivid to drive in normal mode.

Thanksfor hint!

I tuned the simulation to 0.5 and area 1
Then under "speed sensitive steering" the "effect" 0.05 and "speed factor" 0.3

The cars now behave quite well in high/med speeds but when driving on low speed bends, one had to still turn the wheel a lot more then one would except. Those were easier to drive with keyboard.
I did not have time to play with "speed sensitive steering" settings lot, so maybe tuning them could help..?