dupertux34 {l Wrote}:Speaking of the map editor, how do i make moving blocks?
- Place a moving block.
- Right click on it
- Press path
- Place paths where you want. This will tell where the moving block will go. In the top right you can see the speed for the next path you are going to place. You can change it with your scroll wheel.
- When you are done, right click anywhere.
- Right click on the block again and check/uncheck activated or looping.
Activated makes the moving block activate at the start of the level. Otherwise you would need something to activate it like a switch.
Looping will make the block start the path over once it finishes.
You also have the abality to make the block pause/stop at a certain point.
- While making the path, hover over the last path you placed (or above the block if you haven't placed any yet)
- Use the scroll wheel to set the pause lenght. If you scroll below 0 then you can set it to stop at that moment.
- Continue building the path. Even if you placed a stop.
The
pause makes the moving block stop for a certain amount of seconds as you would probably expect. Once the time is over, the moving block will continue its path.
The
stop will make the moving block stop. It won't continue until it gets activated by something like a switch.